Paste

• Tell the user that their tip may need to be changed if the pressure is over 2000 
• Explicitly tell users their board must be flat for extrusion to work properly 
• Faster loading of alignment page 
• Display % of paste remaining in syringe on the left side 
• Show the pressure inside syringe during build and settings on the left side. This allows a quick diagnostic on the tip 
• Z-Height auto-alignment is not more consistent 
• Guidelines included interface for the line test
• Improved instructions on the settings page explaining the effect of each setting 
• Fixed some contours seemed to be printed twice

Printing

• Utilities available for the Printing Process in the main screen 
• Replaced "pitch" with "clearance" in all reference material and software
• Fixed some gaps caused by nozzles never firing.

Safety

• The printer will stop all motion when the Lid is open. (If the enclosure is installed) 
• The LED ring will become red when temperature is above 55C